Roland D-50 - Page 30

WRITING
30
Step 2
Step 3
Step 4
Step 5
Push the Write Button,
Dad ebatistestespeote beaded pe Patch Write
Write to Sure 7 CEntervExit?
Destination Patch Number
If
you
wish
to
rewrite
the
Patch,
skip
the
following
two
procedures
and
go
to
step
4,
but
if
you
wish
to
write
the
edited
Patch
to
a
different
Patch
number,
change
the
destination
Patch
number
as
follows,
@To
write
the
Patch
into
the
internal
memory
of
the
D—50,
push
the
Internal
Button,
and
to
write
onto
the
Memory
Card,
push
the
Card
Button.
@Assign
the
Bank
and
Number
of
the
destination
Patch
by
using
the
Patch
Buttons.
To leave the writing mode, simply push the Exit Button.
Push the Enter Key.
When
writing
is
completed,
the
Display
responds
as
shown
below
and
then
returns
to
the
Play
mode
indication.
%*If the Display does not respond as in the above indication, see "Error
Messages” on page 74 in the Advance Course, and repeat the writing
procedure carefully,
Return the Memory Protect to ON,
(as in Step 1.)
Memory
Protect
is
the
function
that
protects
the
existing
data
from
accidental
erasure.
Be
sure
to
set
Memory
Protect
to
ON
except
when
writing
new
data,
*When the unit is turned off and on again, the Memory Protect is
automatically returned to ON.