Roland D-50 - Page 69

TONE PARAMETERS
@ Cutoff Frequency BORA
This sets the cutoff point of the TVF from 0 to 100. As you
lower the value, higher frequencies are removed and the waveform
gradually become an approximation of a sine wave, then the sound
will finally fade out.
set V Cutoff Point Frequency t
et Value
Level aN S\S
Cutoff Point Frequency t
a
Cutoff Point Frequency
Level
@ Resonance
This boosts the cutoff point from 0 to 30, As you increase the
value, specific harmonics are emphasized and the sound will
become more unusual, more electronic in nature.
Frequency
Set Value! Level A
— |—" wn
Frequency
Level :
— \ an
0 Frequency
37