Roland DP-970 - Applying Effects to the Sound; Adding Reverberation to the Sound (Reverb); Changing the Depth of the Reverb Effect

23
Chapter 2. Performance
Applying Effects to the Sound
fig.panel2-5
■ Adding Reverberation to the Sound (Reverb)
By applying the reverb effect you can produce a pleasant reverberation, making it
sound as though you were performing in a concert hall.
1
Press the [Reverb] button.
The button’s indicator will light, and a reverb effect will be applied to the sound.
To cancel the reverb effect, press the [Reverb] button, getting its indicator to go dark.
■ Changing the depth of the reverb effect
The amount (depth) of the reverb effect can be set to any of eight levels.
2
Hold down the [Reverb] button and press the [-] or [+] button.
The currently specified value will be displayed.
Higher values will produce a deeper effect.
1
2
When you play back an
internal song, the reverb effect
will automatically be turned
on (the button’s indicator
lights).
When the power is turned on,
reverb is set to “4.”
When you hold down the
[Reverb] button, the currently
specified reverb depth value
will be displayed.
DP-970_e.book 23 ページ ２００７年１月１６日 火曜日 午後１時４２分