Roland DP-970 - Changing the Metronome Volume

30
Chapter 2. Performance
Stopping the metronome
5
Once again press the [Metronome/Count In] button, getting the button to
go dark.
The metronome will stop.
■ Changing the Metronome Volume
The volume of the metronome can be adjusted, with nine volume levels available.
1 Hold down the [Metronome/Count In] button and press the [-] or [+]
button.
The currently specified volume will be displayed.
Continue to hold down the [Metronome/Count In] button, and press the [-] or [+]
button to sound the metronome, and change the volume.
fig.disp-metrovol
This is set to “4” when the
instrument is turned on.
When you hold down the
[Metronome/Count In] button,
the currently specified
metronome volume will be
displayed.
NOTE
When the metronome volume
is set to “0,” the metronome
sound does not play.
DP-970_e.book 30 ページ ２００７年１月１６日 火曜日 午後１時４２分