Roland EGX-300 - User Manual

USER'S MANUAL
Thank you very much for purchasing the EGX-300.
• To ensure correct and safe usage with a full under-
standing of this product's performance, please be sure
to read through this manual completely and store it in
a safe location.
• Unauthorized copying or transferral, in whole or in
part, of this manual is prohibited.
• The contents of this operation manual and the
specifications of this product are subject to change
without notice.
• The operation manual and the product have been
prepared and tested as much as possible. If you find
any misprint or error, please inform us.
• Roland DG Corp. assumes no responsibility for any
direct or indirect loss or damage which may occur
through use of this product, regardless of any failure to
perform on the part of this product.
• Roland DG Corp. assumes no responsibility for any
direct or indirect loss or damage which may occur
with respect to any article made using this product.

Summary

To Ensure Safe Use

Understanding Safety Notices and Symbols

Explains the meaning of WARNING, CAUTION notices and safety symbols used in the manual.

General Safety Precautions (CAUTION)

Details critical safety instructions to prevent injury or damage during operation.

Safety Labels on the Unit

Describes safety labels affixed to the machine exterior and their meanings.

Part 1 Startup Procedures

Checking Included Accessories

Lists and describes all included accessories to verify shipment contents upon unpacking.

EGX-300 Part Identification

Identifies and explains the various parts and their functions on the EGX-300 unit.

Installation and Software Setup

Provides instructions for installing the EGX-300 hardware and its accompanying software.

EGX-300 Operational Setup

Covers connection parameters, workpiece loading, cutter installation, and origin point setting.

Cutting Conditions and Data Transfer

Explains how to set cutting parameters and send job data to the EGX-300.

Finishing Cutting Operations

Covers post-cutting procedures like detaching the cutter and cleaning the machine.

Part 2 Users Reference

EGX-300 Cutting Area and Operation

Specifies the maximum cutting dimensions and explains basic operational functions.

Display Menu Explanations

Details the various menus and their options available on the EGX-300's liquid-crystal display.

EGX-300 Maintenance and Troubleshooting

Provides instructions for routine maintenance, error resolution, and troubleshooting common issues.

EGX-300 Command and Control Instructions

Details command sets, device control instructions, and lists error/other messages.

EGX-300 Technical Specifications and Options

Lists technical specifications, optional accessories, and interface details.

Roland EGX-300 Specifications

General

Drive System	Stepper motor
Interface	USB
Software	Dr. Engrave
Power Supply	AC 100-240V, 50/60 Hz
Engraving Method	Rotary
Operating Noise	60 dB