Roland EGX-30 - User Manual

USER'S MANUAL
Thank you very much for purchasing the EGX-30.
• To ensure correct and safe usage with a full under-
standing of this product's performance, please be sure
to read through this manual completely and store it in
a safe location.
• Unauthorized copying or transferral, in whole or in
part, of this manual is prohibited.
• The contents of this operation manual and the
specifications of this product are subject to change
without notice.
• The operation manual and the product have been
prepared and tested as much as possible. If you find
any misprint or error, please inform us.
• Roland DG Corp. assumes no responsibility for any
direct or indirect loss or damage which may occur
through use of this product, regardless of any failure to
perform on the part of this product.
• Roland DG Corp. assumes no responsibility for any
direct or indirect loss or damage which may occur
with respect to any article made using this product.

Roland EGX-30 Specifications

General

Type	Desktop Engraver
Drive System	Stepper Motor
Software	Roland EngraveStudio
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Max Material Thickness	1.2 in (30 mm)
Resolution	0.01 mm
Spindle Speed	up to 30, 000 RPM
Spindle Motor	DC Motor
Weight	30 kg

Summary

Essential Safety Information

Understanding Warning and Caution Notices

Explanation of hazard alert symbols used in the manual.

Interpreting Safety Symbols

Meaning of symbols indicating prohibition, mandatory action, or danger.

Electrical Safety Precautions

Critical safety measures regarding power supply, cords, and grounding.

Operational Safety Precautions

Handling and Environmental Safety

Precautions for use in safe environments and proper handling of the unit.

Device Components

Identification of Front and Rear Parts

Control Panel Operation

Control Panel Layout and Functions

Overview of knobs, keys, and LEDs on the control panel.

Key Operations and Mode Selection

Explanation of how to use the control panel keys for various functions.

Workflow and Task Execution

Standard EGX-30 Task Flow

Installation and Connectivity

Connecting Peripherals and Computer

Software Installation

Software Setup Procedure

Power-On Procedure

Starting Up the EGX-30 Unit

Material Preparation

Securing Materials for Cutting

Tool Installation and Adjustment

Installing the Engraving Cutter

Procedure for installing the character cutter for engraving.

Installing the Diamond Scraper

Procedure for installing the diamond scraper for scoring.

Tool Depth Control

Setting Engraving Depth

How to adjust the tool depth for precise engraving.

Removing Tools and Depth Nose

Origin Point Setup

Defining the Materials Origin Point

Instructions for setting the starting point for cutting operations.

Tool and Material Guide

Compatible Tools and Materials

Test Cutting Procedure

Performing Test Cuts

How to conduct test cuts to verify settings and material compatibility.

Cutting Parameter Configuration

Adjusting Spindle Speed

Setting the Cutting Speed

Data Operations and Control

Sending Cutting Data to the Unit

Ending Cutting Operations

Steps for Safely Finishing Operations

Troubleshooting Guide

Resolving Power and Connection Issues

Solutions for problems related to power and computer connectivity.

Addressing Cutting and Alignment Errors

Troubleshooting tips for material cutting and output result alignment.

Technical Specifications

EGX-30 Detailed Specifications

Comprehensive technical data including dimensions, performance, and power.