19
For the Scoring (Diamond scraper) * Use SELECT key to choose "SCORE" as the mode.
3
4
1
2
When performing scoring, be sure to purchase the diamond scraper (optionally available).
Tighten the screw securely to secure the tool in
place.
* If the depth regulator nose is
installed, it should be removed.
Loosen the screw for the engraving-tool holder and
lower the blade of the diamond scraper until it
protrudes about 1 mm (1/16 in.) from the tip of the
adapter.
Loosen the tool mounting screw and insert the
special adapter into the tool carriage.
Hexagonal
screw driver
Engraving-
tool holder
1. Turn in the
direction of the
arrow to tighten
provisionally.
2. Rotate in the direction
of the arrow.
1 mm (1/16 in.)
Hexagonal
screw driver
Hexagonal
screw driver
Retighten the tool mounting
screw to secure in place.
Provisionally tighten the diamond scraper in the
engraving-tool holder, and insert it into the tool
carriage.
To Next Page
Loading...
