26
Appendix A List of Options
Appendix B Instruction Support Chart
mode 2
Others
Compatible. .........
Incompatible. .......
Ignored. ...............
The EGX-30 comes with CAMM-GL II, and supports the following commands.
However, these commands are not supported in mode 1.
A "CAMM-GL II Programmer's Manual" is available for separate purchase for those wishing to create their own programs for this
machine. For further information, please contact the nearest Roland DG Corp. dealer or distributor.
Item Model number Description
Character cutter ZEC-A2013 φ 3.175 x 114(L) x 0.127(W)
ZEC-A2025
High speed steel
φ 3.175 x 114(L) x 0.254(W)
ZEC-A2051 φ 3.175 x 114(L) x 0.508(W)
ZEC-A2076 φ 3.175 x 114(L) x 0.762(W)
Flat cutter ZEC-A2150 φ 3.175 x 114(L) x 1.52(W)
ZEC-A2190
High speed steel
φ 3.175 x 114(L) x 1.91(W)
ZEC-A2230 φ 3.175 x 114(L) x 2.29(W)
ZEC-A2320 φ 3.175 x 114(L) x 3.175(W)
Diamond scraper ZDC-A2000 Diamond φ 3.175 x 127(L)
Bearing for the depth regulator nose DRN-20 3 pieces
Adhesive sheet for securing material AS-10 210 x 140 mm (8-1/4 x 5-1/2 in.) 10 sheets
Instru- Compati- Instru- Compati- Instru- Compati- Instru- Compati- Instru- Compati- Instru- Compati-
ction billity ction billity ction billity ction billity ction billity ction billity
AA DR IP OI PU SS
AR DT IW OO RA TL
CA EA LB OP RR UC
CC ER LT OS SA VS
CI ES X OA OW SC WD
CP EW OC PA SI WG
CS FT OE PD SL XT
DF IM OF PR SM YT
DI IN OH PT SR
Instru- Compati- Instru- Compati- Instru- Compati-
ction billity ction billity ction billity
!VZ !ST !NR
Unit : mm
φ : Cutting tool diameter
L : Cutting tool length
W : Blade width
D : Blade diameter
To Next Page
Loading...
