Roland EGX-30 - Installation and Connectivity; Connecting Peripherals and Computer

13
The Setup program starts. Follow the messages to carry
out setup and finish setting up the program.
4
When all installation finishes, the screen show below
appears.
Click [Close].
7
* When the setup for one program finishes, the
setup for the next program starts.
In the interval until the next setup starts, a dialog
box showing the progress of processing is
displayed.
The driver settings appear.
When you make the settings for the communication
parameters of EGX-30, make the parameters match the
values displayed here.
Click [Close] to finish installing the driver.
6
If the following screen appears while installing the
driver, click the drop-down arrow and choose the port
for the cable connected to the computer.
When using an RS-232C (serial) cable
[COM1:] or [COM2:]
When using a printer (parallel) cable
[LPT1:] or [LPT2:]
5
After returning to the menu screen for installation, click
.
8
Remove the CD-ROM from the CD-ROM drive.
9