Roland EV-1-WL - Connecting the EV-1-WL to EV-1-WL Editor (Android)

2
Connecting the EV-1-WL to EV-1-WL Editor
(Android)
1. Power-on the EV-1-WL unit and the
mobile device.
2. Make sure that the Bluetooth indicator
on the EV-1-WL is blinking blue.
If the indicator is blinking white or is lit up blue,
operate the device as shown below to make the
indicator blink blue.
Blinking
white
Quickly press the EV-1-WL’s [Bluetooth]
button twice.
Lit blue
The unit is connected to a dierent device.
Disconnect from the device that’s already
connected, or long-press the [Bluetooth]
button on the EV-1-WL.
3. In your mobile device’s settings, turn
Bluetooth switch on.
NOTE
Even if the devices list on the mobile device shows
“EV-1-WL” or “EV-1-WL+,” don’t tap these.