Roland EV-1-WL - Page 43

43
REVERB parameters
Parameter Value Explanation
TYPE Refer to REVERB types
REVERB TIME 0.1–10.0s
Adjusts the length
(time) of reverberation.
PRE DELAY 0–500ms
Adjusts the time until
the reverb sound starts
to output.
LOW CUT
FLAT,
20Hz–
800Hz
Sets the frequency at
which the low cut lter
begins to take eect.
When “FLAT” is selected,
the low cut lter has no
eect.
HIGH CUT
630Hz–
12.5kHz,
FLAT
Sets the frequency at
which the high cut lter
begins to take eect.
When “FLAT” is selected,
the high cut lter has
no eect.
EFFECT LEVEL
GUITAR/INST
0–100
Adjusts the volume of
the reverb sound for
GUITAR/INSTRUMENT.
EFFECT LEVEL MIC 0–100
Adjusts the volume of
the reverb sound for
MIC.
DIRECT MIX 0–100
Adjusts the volume of
the direct sound.