Roland EV-1-WL - Page 54

54
BT-DUAL Bluetooth indicator
Lit blue
EV-1-WL Bluetooth indicator (*1)
Lit white, lit
blue
AC-22LX Editor device name
EV-1-WL+
*1 To check the indicator status, quickly press the
Bluetooth button twice. The color switches between
white and blue (remaining lit up).
4. Congure the parameters to be
controlled by the EV-1-WL (p. 55).
NOTE
¹ You can’t use the AC-22LX Editor and the EV-1-WL
Editor at the same time.
¹ The AC-22LX and EV-1-WL automatically connect
next time they are restarted. To connect the
AC-22LX Editor, you must follow the steps in
“Connection 2” each time.
¹ If the devices do not pair after one minute has
passed, pairing mode is automatically canceled.
¹ The EV-1-WL remembers the information for the
last Bluetooth device to which it was connected.
When connecting to a dierent device after
connecting to the AC-22LX, or when turning
o the power while the Bluetooth indicator is
blinking white (not connected), or when doing
a factory reset of the EV-1-WL, the device does
not pair automatically. In this case, go back to
“Connection 1” to congure the settings.