Roland EV-1-WL - Page 64

64
3. Setting the parameters to control via
the FS-1-WL (p. 65).
NOTE
¹ You cannot use the AC-22LX Editor and the
FS-1-WL Editor at the same time.
¹ The AC-22LX and FS-1-WL are connected
automatically next time they are restarted. To
connect the AC-22LX Editor you must perform
“Connection 2” each time.
¹ If the devices do not pair after one minute has
passed, pairing mode is automatically canceled.
¹ The FS-1-WL remembers the information for the last
Bluetooth device to which it was connected. When
connecting to a dierent device after connecting
to the AC-22LX, or when turning o the power
while the Bluetooth indicator is blinking white
(not connected), or when doing a factory reset of
the FS-1-WL, the unit does not pair automatically.
In this case, you must start from “Connection 1” to
congure the settings.