Roland fp-30 - Page 31

MIDI Implementation
31
70150: Monaural Delay
A delay that provides a long delay time.
No Parameter Value Description
1 Delay Mode 0–1 ms, note
When this is set to “note,” the
eect is synchronized with
the tempo.
2 Delay Time 0–127 1–2540 ms
Delay time from when the
original sound is heard to
when the delay sound is
heard (Hz)
3
Delay Time
#1
0–21 note
Delay time from when the
original sound is heard to
when the delay sound is
heard (note)
4 Phase 0–1
NORMAL,
INVERSE
Phase of the delay (NORMAL:
non-inverted, INVERSE:
inverted)
5 Feedback 49–89 0–+80 %
Proportion of the delay sound
that is to be returned to the
input
6 HF Damp 0 –17
200–8000
Hz, Bypass
Frequency at which the
high-frequency content of the
delayed sound will be cut
(Bypass: no cut)
7 Pan 0 –127 L64–63R Panning of the delay sound
8 Low Gain 0–30 -15–+15 dB
Amount of boost/cut for the
high-frequency range
9 High Gain 0–30 -15–+15 dB
Amount of boost/cut for the
high-frequency range
10 Balance #2 0–100
D100:0W–
D0:100W
Volume balance of the
original sound (D) and the
delay sound (W)
11 Level 0–127 0 –127 Output volume
70151: Modulation Delay
Adds modulation to the delayed sound.
No Parameter Value Description
1
Delay Left
Mode
0–1 ms, note
When this is set to “note,” the
eect is synchronized with
the tempo.
2 Delay Left 0 –127 1–1270 ms
Adjusts the time until the
delay sound is heard. (Hz)
3 Delay Left 0–21 note
Adjusts the time until the
delay sound is heard. (note)
4
Delay Right
Mode
0–1 ms, note
Settings of the Delay Right
The parameters are the same
as for the Delay Left.
5 Delay Right 0–127 1–1270 ms
6 Delay Right 0–21 note
7
Feedback
Mode
0–1
Normal,
Cross
Selects the way in which delay
sound is fed back into the
eect.
8 Feedback 49–89 0–+80 %
Adjusts the amount of the
delay sound that’s fed back
into the eect.
9 HF Damp 0 –17
200–8000
Hz, Bypass
Adjusts the frequency above
which sound fed back to the
eect is ltered out. If you
don’t want to lter out any
high frequencies, set this
parameter to Bypass.
10 Rate Mode 0–1 Hz, note
When this is set to “note,” the
eect is synchronized with
the tempo.
11 Rate 1–127
0.05–10.00
Hz
Frequency of modulation (Hz)
12 Rate 0–21 note
Frequency of modulation
(note)
13 Depth #1 0 –127 0 –127 Depth of modulation
14 Phase 0–90 0–180 deg Spatial spread of the sound
No Parameter Value Description
15 Low Gain 0–30 -15–+15 dB
Gain of the low frequency
range
16 High Gain 0–30 -15–+15 dB
Gain of the high frequency
range
17 Balance #2 0 –100
D100:0W–
D0:100W
Volume balance between the
direct sound (D) and the delay
sound (W)
18 Level 0–127 0–127 Output level
70152: Triple Tap Delay
Produces three delay sounds; center, left and right.
No Parameter Value Description
1
Delay Left
Mode
0–1 ms, note
When this is set to “note,” the
eect is synchronized with
the tempo.
2 Delay Left 0 –127 1–2540 ms
Adjusts the time until the
delay sound is heard. (Hz)
3 Delay Left 0–21 note
Adjusts the time until the
delay sound is heard. (note)
4
Delay Right
Mode
0–1 ms, note
Settings of the Delay Right
The parameters are the same
as for the Delay Left.
5 Delay Right 0–127 1–2540 ms
6 Delay Right 0–21 note
7
Delay Center
Mode
0–1 ms, note
Settings of the Delay Center
The parameters are the same
as for the Delay Left.
8 Delay Center 0–127 1–2540 ms
9 Delay Center 0–21 note
10
Center
Feedback #1
49–89 0–+80 %
Adjusts the amount of the
delay sound that’s fed back
into the eect.
11 HF Damp 0 –17
200–8000
Hz, Bypass
Adjusts the frequency above
which sound fed back to the
eect is ltered out. If you do
not want to lter out any high
frequencies, set this
parameter to Bypass.
12 Left Level 0–127 0–127 Volume of each delay
13 Right Level 0 –127 0–127 Volume of each delay
14 Center Level 0–127 0 –127 Volume of each delay
15 Low Gain 0–30 -15–+15 dB
Gain of the low frequency
range
16 High Gain 0–30 -15–+15 dB
Gain of the high frequency
range
17 Balance #2 0 –100
D100:0W–
D0:100W
Volume balance between the
direct sound (D) and the delay
sound (W)
18 Level 0–127 0–127 Output level