30
°
Error Messages
Indication Meaning
Error 2
An error occurred during writing. The external media may be corrupted.
Insert other external media and try again. Alternatively, you can initialize the external media (p. 25).
The internal memory might be damaged. Format the internal memory (p. 25).
Error 10
No external media is inserted. Insert the external media and try again.
The internal memory might be damaged. Format the internal memory (p. 25).
Error 11
There is not sucient free memory in the save destination.
Either insert other external media or delete unneeded les and try again.
Error 14
An error occurred during reading. The external media may be corrupted.
Insert other external media and try again. Alternatively, you can initialize the external media (p. 25).
The internal memory might be damaged. Format the internal memory (p. 25).
Error 15 The le is unreadable. The data format is not compatible with the unit.
Error 18
This audio format is not supported.
Please use 44.1 kHz 16-bit linear WAV format or 44.1 kHz 64 kbps–320 kbps MP3 format audio les.
Error 30 Internal memory capacity of the unit is full.
Error 40
The unit cannot deal with the excessive MIDI data sent from the external MIDI device.
Reduce the amount of MIDI data sent to the unit.
Error 41 A MIDI cable was disconnected. Connect the MIDI cable correctly.
Error 43 A MIDI transmission error has occurred. Check the MIDI cable and connected MIDI device.
Error 51
There may be a problem with the system. Repeat the procedure from the beginning. If it is not solved after you have tried several times, contact the Roland
service center.
Error 65
The USB ash drive connector was subjected to excessive current. Make sure that there is no problem with the external media, then turn the power o, then
on again.
Parameter Explanation
Settings Saved in
Registrations
Items Stored by Memory
Backup
Settings Stored
Immediately When Edited
Selected tone (including Split or Dual tones)
t
Dual Play On/O
t
Split Play On/O
t
Part Volume
t
Split Point Split Point
t
Right Shift/Left Shift Octave shift of the right-hand and left-hand tone
t
Tone 1 Shift/Tone 2 Shift Octave shift of tone 1 and tone 2
t
Transpose Transpose on/o and transpose value
t
Ambience Type Ambience type
t*1 t
Ambience Depth Depth of the ambience eect
t t
Rotary Speed Modulation speed of the rotary eect
t
Modulation Speed Speed at which the sound is modulated
t
Key Touch Key Touch
t t
Damper Pedal Part Damper pedal part setting
t
Center Pedal Part Center pedal part setting
t
Center Pedal Function of the center pedal
t
Left Pedal Part Left pedal part setting
t
Left Pedal Function of the left pedal
t
Reg. Pedal Shift Registration pedal shift setting
t*2
MIDI Transmit Ch. MIDI transmit channel
t t
Reg. Transmit Ch.
Tone switching information
t
Reg. PC
Reg. Bank MSB
Reg. Bank LSB
Mic Eects Mic eects setting
t
Headphones 3D Ambience Headphones 3D Ambience
t
Hammer Response Hammer response
t
Metronome Metronome (volume, sound, downbeat)
t
Master Tuning Master Tuning
t
Temperament Tuning method
t
Temperament Key Base note for the tuning method
t
Input/Bluetooth Vol. Input/Bluetooth volume
t
USB Audio Input Vol. USB Audio input volume
t
SMF Play Mode SMF playback mode
t
Display Contrast Display contrast
t
Panel Brightness Brightness of the buttons
t
All settings of the Bluetooth function
t
Speaker Auto Mute Settings of the Speaker Auto Mute function
t
Auto O Auto o
t
Equalizer Equalizer settings
t
*1 Saved in registrations only for the FP-90X.
*2 The “Reg. Pedal Shift” setting is saved on the USB ash drive when you execute Registration Set Export.
°
Saved Settings
To Next Page
Loading...
Need help?
General
Weight and Dimensions
