Getting Ready to Play
55
Attaching the Music Rest
1. Insert the music rest into the slit on the top of the
FP-E50.
NOTE
¹ When moving the FP-E50, be sure to remove the music rest as a
safety precaution.
¹ Do not apply excessive force to the music rest.
¹ The music rest is not designed to accept the placement of
laptops or other heavy objects.
Turning On/O the Power
Once everything is properly connected (p. 3), be sure to follow the
procedure below to turn on their power. If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure.
Turning on the Power
1. Move the [Master Volume] slider all the way down to
minimize the volume.
2. Press the [ĀĀ] (power) switch to turn on the power.
NOTE
¹ Before turning the unit on/o, always be sure to turn the
volume down. Even with the volume turned down, you might
hear some sound when switching the unit on/o. However, this
is normal and does not indicate a malfunction.
¹ To ensure proper operation of the wheel, make sure not to
touch the wheel when turning the FP-E50’s power on.
Turning o the Power
1. Move the [Master Volume] slider all the way down to
minimize the volume.
2. Hold down the [ĀĀ] (power) button until the display
shows “POWER OFF”.
Release the button, and the power turns o.
NOTE
¹ Never turn o the power of the FP-E50 during playback or
recording, or when loading/saving data to or from the USB ash
drive.
¹ When you turn o the power of the FP-E50, the contents of the
loaded (currently edited) scene are lost. Save any important
data before you turn o the power.
¹ If you need to turn o the power completely, press the [Ā]
(power) button; after the unit’s power switch has been turned
o, disconnect the plug from the AC outlet.
Adjusting the Overall Volume
Here’s how to adjust the volume of your keyboard playing or the
playback volume of an internal song.
If headphones are connected, use the [Master Volume] slider to adjust
the headphone volume.
1. Move the [Master Volume] slider to adjust the overall
volume.
Adjust the volume while you play the keyboard to produce sound.
Move the slider up to raise the volume, and move the slider down to lower
the volume.
Making the Power Automatically Turn O
After a Time
(Auto O)
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (Auto
O function). If you do not want the power to be turned o
automatically, disengage the Auto O function.
* Factory setting: 240 min.
¹ Any settings that you are in the process of editing will be lost when
the power is turned o. If you have any settings that you want to
keep, you should save them beforehand.
¹ To restore power, turn the power on again.
Turning o the Auto-O Function
If you don’t want the instrument to turn o automatically, change the
“Auto O” setting to “O”.
1. Press the [Menu] button.
The Menu screen appears.
2. Use the [ää] [åå] buttons to select “SYSTEM”, and then
press the [Enter] button.
3. Use the [ää] [åå] buttons to select “GENERAL”, and then
press the [Enter] button.
4. Use the [ää] [åå] buttons to select “Auto O”.
5. Use the [Dec] [Inc] buttons to change the value.
Parameter Value
Auto Off Off, 10, 30, 240 (minutes)
MEMO
The Auto O setting is saved automatically.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
