12
Synth Bass (PRESET PATCH: H-1)
2 3 7
1 5 46 4 9
8
1
Press the [CANCEL/SHIFT] button and [WRITE] button to recall the initialized sound.
The sawtooth wave is selected. Press the [VARIATION] button to light the [WAVE] button into red.
2
Since the bass usually sounds in the lower registers, turn the [PITCH] knob to the left so the sound is
lowered by an octave.
3
Set the FILTER [CUTOFF] knob between 8 and 9 o’clock.
The sound will diminish.
4
Next, you need to specify the character of the sound’s sustained portion. Set the FILTER ENV [ENV
DEPTH] slider to the 60% position. Set the FILTER ENV [S] slider to the 65% position. The sound will
be somewhat muted.
5
Now you’re ready to create the attack. Set the FILTER ENV [D] slider to the 35% position. The attack
will be softened.
6
To simulate the e ect of keeping a nger on the string and sliding to a di erent fret,
press the [MONO] button so it’s lit.
7
Set the [RESONANCE] knob to the 11 o’clock position, giving the sound a distinctive character.
8
Set the AMP ENV [S] slider to the maximum position, and set the [A] [D] [R] sliders to the minimum
position.
9
Make ne adjustments to the FILTER ENV [ENV DEPTH] slider to determine the overall tonal
character.
This synth bass is similar to the sound in chapter 2 “Recall and Edit Presets”, chapter 5 “How to Make
a Sound” of the
DVD.
Examples of Creating Sounds
APPENDIX
To Next Page
Loading...
