13
Synth Lead (PRESET PATCH: H-7)
7 32
9
4
11
105
8
61
1
Press the [CANCEL/SHIFT] button and [WRITE] button to recall the initialized sound.
The sawtooth wave is selected. Press the [VARIATION] button to light the [WAVE] button into
red.
2
Turn the [PITCH] knob to the right so the sound is raised by an octave.
3
Set the FILTER [CUTOFF] knob to the 2 o’clock position.
4
Set the FILTER [RESONANCE] knob to the 8 o’clock position.
5
Now you’re ready to create the attack.
Set the FILTER ENV [A] [D] [S] [R] sliders all to the lowest position.
6
Next, you need to determine the overall tonal character.
Slightly raise the FILTER ENV [ENV DEPTH] slider.
7
Press the FILTER [SLOPE] button to select -24 dB.
The sound will become a bit softer.
8
Set the AMP ENV [S] slider to the maximum position, and set the [A] [D] [R] sliders
to the minimum position.
9
To get a more appropriate lead feeling, press the [MONO] button so it’s lit.
With this setting, the patch will play only single notes, and if you press a key while still holding
the previous key, the sound will change smoothly to the new pitch.
10
Press the [REVERB] button so it’s lit.
11
Turn the [CONTROL 1] knob to add reverberation to the lead sound.
This synth lead is similar to the sound in chapter 2 “Recall and Edit Presets” of the
DVD.
To Next Page
Loading...
