66
Chapter 6 Using the Built-in Effects
FINE B (Fine pitch B) -100–+100
Adjust the pitch shift amount in 2-cent units (1 cent = 1/
100th of a semitone) for pitch shift B.
PRE DELAY A (Pre delay time A) 0.0–500 ms
Specify the time delay from the original sound until the pitch
shift A sound is heard.
PRE DELAY B (Pre delay time B) 0.0–500 ms
Specify the time delay from the original sound until the pitch
shift B sound is heard.
PAN A (Output pan A) L64–0–R63
Specify the stereo location of the pitch shift A sound.
A setting of L64 is far left, 0 is center, and R63 is far right.
PAN B (Output pan B) L64–0–R63
Specify the stereo location of the pitch shift B sound.
A setting of L64 is far left, 0 is center, and R63 is far right.
LVL BALANCE (Level balance) A100:0B–A0:100B
Adjust the volume balance between the pitch shift A and
pitch shift B sounds.
With a setting of A100:0B only the pitch shift A sound will be
output, and with a setting of A0:100B only the pitch shift B
sound will be output.
BALANCE (Effect balance) D100:0E–D0:100E
Adjust the volume balance between the original sound and
the pitch shift sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the pitch shift
sound will be output.
LEVEL (Output level) 0–127
Specify the output volume.
23: FB-P.SFT (Feedback pitch shifter)
This is a pitch shifter that is able to return the pitch shifted
sound back to the input.
fig.6-26
MODE (Pitch shifter mode) 1–5
Higher settings will cause the response to be slower, but the
pitch will be steadier.
COARSE (Coarse pitch) -24–+12 #
Specify the pitch shift amount in semitone steps. (-2–+1 octave)
FINE (Fine pitch) -100–+100
Adjust the pitch shift amount in 2-cent steps (1 cent = 1/
100th of a semitone).
PRE DELAY (Pre delay time) 0.0–500 ms
Specify the time delay from the original sound until the pitch
shift sound is heard.
FEEDBACK -98–+98 %
Specify the proportion (%) of the pitch shift sound that is to
be returned to the input.
Positive (+) settings will return the sound to the input with
the original phase, while negative (-) settings produce an
inverted phase.
PAN (Output pan) L64–0–R63
Specify the stereo location of the pitch shift sound.
A setting of L64 is far left, 0 is center, and R63 is far right.
LOW GAIN -15–+15 dB
Specify the gain (amount of boost or cut) of the low
frequency range.
Positive (+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN -15–+15 dB
Specify the gain (amount of boost or cut) of the high
frequency range.
Positive (+) settings will emphasize (boost) the high
frequency range.
BALANCE (Effect balance) D100:0E–D0:100E
Specify the volume balance between the original sound and
the pitch shift sound.
With a setting of D100:0E only the original sound will be
output, and with a setting of D0:100E only the pitch shift
sound will be output.
LEVEL (Output level) 0–127
Specify the output volume.
L in
R in
L out
R out
2-Band
EQ
Balance E
Balance E
Balance D
Balance D
2-Band
EQ
Feedback
Pitch Shifter
To Next Page
