52
Playing Back Songs
With the internal songs, you can select the performance part that is to be played back.
You can also practice each hand separately while playing along with the song.
fig.Panel-TrackMute-e.eps
1.
Select the song that you want to play (p. 48).
2.
Press the [ ] button to play the song.
3.
Select the part that you don’t want to play back.
Press the Track [Left] button, Track [Right] button, or the Track [Accomp] button.
The button you pressed will go out, and the corresponding part will no longer be heard.
Temporarily silencing a specific part in this way is called “muting.”
For example, if you want to practice the right-hand part, press the Track [Right] button
so its illumination is turned off. When you play back the song, the right-hand part will
not play.
If you again press the button you selected in step 3, so the button is lit, the sound of that part will
be heard.
Mute settings will be cleared when you switch songs.
Listening to Each Part Separately
The performance data is assigned to the Track buttons as shown below.
fig.TrackButtons-e.eps
The left-hand performance is assigned to the Track [Left]
button, the right-hand performance is assigned to the
Track [Right] button, and other performance is assigned
to the Track [Accomp] button. “Tracks” are areas in
which music data is held, and buttons [Left], [Right], and
[Accomp] are referred to as the “track buttons.”
Right-hand
Part
Accompaniment
Part
Left-hand Part
NOTE
HP207_e.book 52 ページ ２００６年１２月２５日 月曜日 午前９時５２分
To Next Page
Loading...
