Roland HP601 - Loading;Saving Piano Setups; Saving Piano Settings (Piano Setup Export); Loading Piano Settings (Piano Setup Import); Setting Page

16
Advanced Operation
˙
Loading/Saving Piano Setups
The piano settings that you make can be used on another HP601 unit
(such as in a music school) if you save your settings on a USB ash
drive and then load them into the other HP601.
* Only piano settings that were created on an HP601 can be loaded.
Settings that are saved as piano settings
Setting Page
Speaker volume p. 6
Headphone volume p. 6
Ambience p. 6
Headphones 3D Ambience p. 6
Brilliance p. 6
Key Touch p. 6
Hammer Response p. 6
Piano Designer settings p. 13
Master Tuning p. 22
Temperament p. 22
Temperament Key p. 22
Volume Limit p. 24
Saving Piano Settings (Piano Setup Export)
1. Connect your USB ash drive to the USB Memory port
(p. 25).
2. Press the [Ambience] button and [Brilliance] button
simultaneously.
3. Use the [K] [J] buttons to select “Piano Setup Export,” and
then press the [s] (Enter) button.
The Piano Setup Export screen appears.
4. Rename the piano settings.
[K] [J] buttons
Select the position at which you want to change
the character.
[–] [+] buttons Change the character.
5. Press the [s] (Enter) button.
The settings are saved.
NOTE
Never turn o the power or disconnect the USB ash drive while
the screen indicates “Executing...”
6. Simultaneously press the [Ambience] button and
[Brilliance] button to exit Function mode.
Loading Piano Settings (Piano Setup Import)
1. Connect your USB ash drive to the USB Memory port
(p. 25).
2. Press the [Ambience] button and [Brilliance] button
simultaneously.
3. Use the [K] [J] buttons to select “Piano Setup Import,” and
then press the [s] (Enter) button.
The Piano Setup Import screen appears.
4. Use the [+] [–] buttons to select the piano settings that you
want to import.
5. Press the [s] (Enter) button.
A conrmation message appears.
If you decide to cancel, press the [u] (Exit) button.
6. Use the [J] button to select “Yes,” and then press the [s]
(Enter) button.
The settings are loaded.
NOTE
Never turn o the power or disconnect the USB ash drive while
the screen indicates “Executing...”
7. Simultaneously press the [Ambience] button and
[Brilliance] button to exit Function mode.