Roland JUNO-D - Page 74

74
Adding effects
16: STEP FLANGER
The Step Flanger effect is a flanger in which the flanger pitch
changes in steps.
fig.MFX-16
17: St DELAY (Stereo Delay)
This is a stereo delay.
When Feedback Mode is NORMAL:
fig.MFX-17a
When Feedback Mode is CROSS:
fig.MFX-17b
Balance
D100:0W–
D0:100W
Adjusts the volume balance be-
tween the direct sound and the
flanger sound.
With a setting of D100:0W only the
direct sound will be output, and
with a setting of D0:100W only the
flanger sound will be output.
Level 0–127 Adjusts the output level.
Parameter
Value Description
Pre Delay
0.0–100 [ms] Adjusts the time delay from
when the direct sound begins
until the flanger sound is heard.
Rate 0.05–10.00 [Hz] Adjusts the rate of modulation.
Depth 0–127 Adjusts the depth of modula-
tion.
Feedback # -98– +98 [%] Adjusts the amount (%) of the
flanger sound that is returned
(fed back) into the input.
Negative (-) settings will invert
the phase.
Step Rate # 0.1–20.0 [Hz],
note *2
Adjusts the rate (period) of pitch
change.
Phase 0–180 [deg] Adjusts the spatial spread of the
sound.
Balance D100:0W–
D0:100W
Adjusts the volume balance be-
tween the direct sound and the
flanger sound.
With a setting of D100:0W only the
direct sound will be output, and
with a setting of D0:100W only the
chorus sound will be output.
Reset OFF, ON This setting determines whether
the period for the pattern is reset
(ON), or not (OFF) when sounds
are played.
While the rhythm guide is play-
ing, the period for the pattern is
not reset even if you set this ON.
Level 0–127 Adjusts the output level.
Parameter
Value Description
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Parameter
Value Description
Feedback Mode
NORMAL,
CROSS
Selects the way in which delay
sound is fed back into the effect.
NORMAL: The left delay sound
will be fed back into the left de-
lay, and the right delay sound
into the right delay.
CROSS: The left delay sound
will be fed back into the right de-
lay, and the right delay sound
into the left delay.
Delay Left 0–420 [ms],
note *1
Adjusts the time from the direct
sound until when the left delay
sound is heard.
Delay Right 0–420 [ms],
note *1
Adjusts the time from the direct
sound until when the right delay
sound is heard.
Phase Left NORMAL,
INVERT
Selects the phase of the left delay
sound.
NORMAL: Phase is not
changed.
INVERT: Phase is inverted.
Phase Right NORMAL,
INVERT
Selects the phase of the right de-
lay sound.
NORMAL: Phase is not
changed.
INVERT: Phase is inverted.
Feedback # -98– +98 [%] Adjusts the proportion (%) of
the delay sound that is fed back
into the effect.
Negative (-) settings will invert
the phase.
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Delay
Delay
JUNO-D_e.book 74 ページ ２００４年６月１１日 金曜日 午後１時２１分