3.Rhythm Edit Mode
EFFECT
Explanations of the parameters
From this point
on,
the main parameters of each button
(and
their
uses) are described,
followed
by explanations on
how
to edit the parameters.
Parameters Selected
by
EFFECT
(3
Pages)
FX SEND (effect senci) page.;
ill
ill.
Dr-d i
127
1
Choi-us 1 F : e
u
e r b 1
l»jn
Dry Level Range:
o
—
127
This
determines
the
level
of the direct or unprocessed sound (the sound
with
no effect applied).
Chorus
Chorus Send Level
Range:
—
1 27
This
determines
the
level
of the signal sent to the chorus.
Reverb Reverb Send
Level
Range:
—
1 27
This determines the level
of
the
signal
sent to the reverb.
The following two
pages
are used for making settings
for the
chorus and reverb.
These
parameters belong to the Performance which are currently called up to the temporary area.
Therefore,
effect data which is set for the Rhythm Set here, must be stored as
Performance
data. However,
when this Rhythm Set is
called
up from another Performance,
the effect
settings
of the selected Performance
are
called up
and
take precedence.
PERFORM CHORUS
{Pertiamiiahce
ClTbrus)p^e
F'EFilFriFiiM
i Type ! Ley
!
Rat- I Dep I Fbk i Gut I
C l-i R \J S
iP-
C !-i X i 1
i;;:i i;;:i
I >S B I
2
1 j B U ! tl I K I
l*T3 Chorus Type Settings: CHO 1
—
3
This determines
the type of chorus.
CH01 Normal
chorus
CH02 Chorus with a slow rate. This also makes a good flanger effect v/hen feedback is applied.
CH03
Chorus
with
pronounced
depth. This applies substantial detuning to the sound.
Chorus Level Range:
—
1 27
This determines the
level
or
volume
of the chorus sound. The greater the
value,
the greater the
level.
141
To Next Page
Loading...
