2.PLAY1NG A
PERFORMANCE
At
The
MIDI receive
channel is a Part
parameter. When using
another keyboard to play the
sound source of the
JV-80, the JV-80 can
easily be matched
to the transmission
channel(s). This is
especially convenient for checking
which
MID!
data is being
transmitted over which channel. Also, by
combining this
function with Patch selection
(the
explanation of which follows), a sound
program can be assigned
to performance data
which was intended originally
for
another sound source, or to data
which has yet to be given a
sound program assignment.
ic
Since a Patcii wiiich has been
selected for a Part can
be changed, even a single
Performance can be
made to piay any
number of various Patches by
switching among them.
This is convenient when
determining the
Patch assignment for an entire
Performance, or when switching only
the Patch of the Part
to
be
played from the
keyboard while using a sequencer for
backing parts.
Part
CD en OCD CD CD C3CD
aaaoa oo ooo
a^
ooc=i
CD CD CD a C3
Internal
Preset
A/B
DATA card
# Check play data
you are unsure of by listening
to each channel in
turn.
• Compare
different instrumentations of the
performance by trying
different sound
programs, switching the
Patches assigned to each Part.
^
Be sure
to reserve
a
sufficient number of voices for
the important Parts in a song, or
Parts that would stand out if the
available
voices were
suddenly
cut off.
Voice
shortage during
realtime performance can be
prevented by reserving a
certain number of voices for
the Part you intend to play live,
while other performance data is
being received from a
sequencer.
53
To Next Page
Loading...
