Roland JX-10 - Page 59

Manual Version 3.21
Page. 59 of 73
JX-10
MIDI Sound module 1
MIDI ................................. CH 1
PROGRAM CHANGE ........... ON
MIDI OUT
MIDI IN
MIDI IN
MIDI THRU
MIDI Sound module 1
MIDI ................................. CH 2
PROGRAM CHANGE........... ON
In this setting, the Program Change number which corresponds to the Tone number of the Upper section you have
selected is sent on the MIDI CH 1 of the MIDI Sound Module.
Tone number
of the JX-10
MIDI Program Change number
which is sent
1
50
100
1
50
100
3. Sending two different Program Change numbers separately to two MIDI Sound Modules by changing
Patch Memories on the JX-10.
• MIDI Setting on the JX-10
[16 PATCH MEMORY ............................ OFF]
[13 UPPER MIDI CH ................................... 1]
[14 LOWER MIDI CH .................................. 2]
[31 UP PROGRAM CHANGE................... ON]
[41 LO PROGRAM CHANGE................... ON]
In this setting, the Program Change number which corresponds to the Tone number of the Upper section in the
Patch Memory you have selected is sent on the MIDI CH 1 of the MIDI Sound Module 1. Likewise the Program
Change number assigned to the Lower Tone number is sent on the MIDI CH 2 of the MIDI Sound Module 2. (only
when the Factors 63 and 64 “PROGRAM CHANGE SEND”, of the Patch Memory are set to OFF).
How to assign the Program Change number to the Tone number is the same as described in “2” on page 44
.
The Factors 63 and 64 “PROGRAM CHANGE SEND” of the Patch Memory can be set separately to values from 1
to 128. The Upper and Lower Program Change numbers which you have set in Factors 63 and 64 are transmitted
independently to each MIDI CH of the MIDI Sound Modules regardless of Program Change ON/OFF messages of
the Upper and Lower sections in the MIDI functions.
TONE NUMBER
PROGRAM CHANGE
SEND
PROGRAM CHANGE
NUMBER
31 UPPER
41 LOWER
63 UPPER
64 LOWER
UPPER
LOWER
1
2
OFF
OFF
1
2
1
2
3
4
3
4