Roland M-12E - Connections and Operation; MI Basic Procedure; 1 Basic Setup with Microphones, Electronic Musical Instruments, Speakers Etc; MM Mixing with Microphones, Electronic

[3] Connections and Operation
@ Basic Procedure:
a Make.sure that the mixer is switched off, then connect (3) Set all the control knobs and volumes to zero.
the power cable to the AC power jack. “4
(4) Make sure that all the connections are correct and
(2) Set up all the peripheral units (refer to the diagram of the secure. Turn all peripheral units on first, then the M-
connections). 12E. (To switch off the units, proceed in the reverse
order.) |
1. Basic setup with microphones, electronic musical instruments, speakers,
Speaker
System
Sa
pe
SRS-120
etc.
ee
ee
Keyboard, Piano, Sound Module etc.
[ U-20, HP-5000, U-110 etc.]
Power Amplifier
SRA-2400
| SRA 200 etc.
Microphone
[DR-45, DR-35 etc.]
Audio Set
@ Mixing with microphones, electronic musical
instrument, etc.
@) While playing the instrument, set the Channel Volume @ Control the tone with the Channel Equalizers.
to 7: | |
* If the Peak signal Indicator (or Pre-fader Signal
Indicator) becomes red too frequently, readjust the
Sens Control Knob.
(2) Raise the Master Volume to an appropriate level, then ©
adjust the volume of each instrument using the Sens
Control knob.
(6) Adjust the volume balance (L+R) with the Panpot.
* The appropriate level is one in which the Peak Signal |
Indicator become constantly green and red during © Adjust the relative volume level of each channel with
input peaks. the Channel Volume. When necessary, adjust the overall
volume with the Master Volume again.
@) After finished to adjust the level of all instruments, ©
adjust the overall volume with the Master Volume.
11