Roland M-12E - 2 Setup Example with Effects Device; Effect Processing with Delay, Reverb, Etc

2. Setup example with effects device.
Speaker System Se ear
[bA-1500 nas | os
SRS-120 etc. seen?
Power Amplifier
SRA-2400
| SRA-1200 etc. |
Effector
Effector
[SDE-3000A, DEP-5 etc.] [DEP-3, DEP-5 etc.]
Equalizer, Limiter etc.
[E-660 etc.]
= Effect Processing with delay, reverb, etc.
(1) Raise the Effect Volume of the desired channel to an
_ appropriate level. Set the overall output level using the
Effect Send Volume in the Master Section and the input
level meter on the effect device.
(2) Adjust the level from the effect device with the Return
Volume.
The direct sound is processed within the mixer, so
return only the effect sound to the mixer.
* The signal from the Effect Send will be taken after
passing the Channel Volume. |
By connecting an effect device to the Channel Insert
Jack, an effect signal can be directly mixed at the
channel.
When aseparate unit (e.g. equalizer etc.) isconnected
between the mixer and power amplifier, you can
control overall sound or tone quality.
12