123
Sampling
Saving a sample
A newly loaded sample, as well as any changes you've made in the
settings for a sample will be lost as soon as you turn off the power. If
you want to keep such data, you must save it as follows.
1.
Press [SAMPLING/RESAMPLING] to access the
Sample Edit screen.
2.
Select the sample that you want to save.
3.
Press [WRITE].
The Write Menu screen will appear.
Make sure that “Sample” is highlighted.
4.
Press [ENTER].
The Sample Name input screen will appear.
5.
Assign a name to the sample.
* If you decide to discard your changes, press [F1 (Cancel)].
6.
When you have finished inputting the name, press
[F6 (Write)].
7.
Use [VALUE] or [INC/DEC] to select the write-
destination sample.
Use [CURSOR (left/right)] to select the bank (User or Card).
8.
Press [F6 (Write)].
A message will ask you for confirmation.
9.
To write the sample, press [F6 (Execute)].
* If you decide to cancel without writing, press [F5 (Cancel)].
• You cannot overwrite onto another sample.
• When saving a stereo sample, two consecutive sample numbers
must be available.
[CURSOR (left/right)]
Moves the cursor (the location at which
to enter/edit a character).
[CURSOR (up/down)] Switches letters between uppercase
and lowercase.
[VALUE] [INC/DEC] Selects characters.
[F1 (Change Type)] Selects the type of character.
Each time you press this, you will al-
ternately select the first character of
the uppercase alphabet (A), lower-
case alphabet (a), or numerals and
symbols (0).
[F2 (Delete)] Deletes the character at the cursor loca-
tion, while shifting the following char-
acters to the left, closing the gap.
[F3 (Insert)] Inserts a space at the cursor location.
MC-909_Ref_e.book 123 ページ ２００５年３月１日 火曜日 午後３時２９分
To Next Page
Loading...
