Roland MC-909 - Realtime Control of Effects; Selecting the Effect that You Want to Control

91
Effects
Effects
Realtime control of effects
The Effects section lets you control effect parameters in real time.
fig.4-01
Selecting the effect that you want
to control
1. Press and hold [KNOB ASSIGN].
The ON/OFF button of the currently selected effect will blink.
2. Still holding down [KNOB ASSIGN], press one of the
[COMP]–[REVERB] buttons to select the effect you
want to control.
If you are controlling a multi-effect parameter that is set in terms of a
note value, it will not be possible to use the knob to select the note.
2 (SRV ROOM) / 3 (SRV HALL) / 4 (SRV PLATE)
Pre Delay
0.0–100.0 ms Delay time from original
sound until reverb is heard
Time 0–127 Length of reverb
Size 1–8 Size of room/hall
High Cut 160–12500 Hz,
BYPASS
Frequency at which the high-
frequency portion of the final
output sound will be cut (BY-
PASS: no cut)
Density 0–127 Density of reverb
Diffusion 0–127 Change in reverb density over
time
Higher settings will cause
density to increase as time
passes. (This is more notice-
able with longer Time set-
tings.)
LF Damp Freq 50–4000 Hz Frequency at which the low-
frequency portion of the re-
verb will be cut
LF Damp
Gain
-36–0 dB Amount of attenuation for LF
Damp (0: no attenuation)
HF Damp
Freq
4000–12500
Hz
Frequency at which the high-
frequency portion of the re-
verb will be cut
HF Damp
Gain
-36–0 dB Amount of attenuation for HF
Damp (0: no attenuation)
Level 0–127 Volume of the reverb sound
Parameter
Range Explanation
Knob Parameter
When “COMP” is selected
[TYPE]
Attack Time
[C1] Release time
[C2] Threshold
When “MFX1/2” is selected
[TYPE]
Select the type of effect (p. 92).
[C1], [C2] Control the assigned function in real
time.
When “REVERB” is selected
[TYPE]
Reverb Type
[C1] Time
[C2] Level
MC-909_Ref_e.book 91 ページ ２００５年３月１日 火曜日 午後３時２９分