Roland MT-32

The following
two
steps are
all
that
is required to set up the
MT-32:
•
MASTER
VOLUME
Set the
overall volume level of
the
MT-32.
SfXAOGftOu*'
VCXAA*
SKECt-*VOU**
(1)
Press the
MASTER VOLUME
button,
(2)
then adjust with the
SELECT/VOLUME
control.
*
If the sound is
distorted, lower the
volume.
If
the reading on
the display remains unchanged when
the
SELECT/VOLUME
knob is
turned, turn
the knob
counterclock-
wise until the volume
number in
the
display begins to change,
then readjust.
{To
prevent
any
sudden change in output
level, the SELECT/
VOLUME control must be turned
to
the
position of output level
as shown
in
the display before
any
adjustment
can be made.)
•
REVERB MODE
Select the reverb mode as
necessary for
the
master output from the
MT-32.
srn'ho
nxcx
SELECT/
VOtUMi
(1)
While holding down the MASTER VOLUME
button and
(2)
press the VOLUME
button,
then
{3)
turn the
SELECT/VOLUME
control to adjust
the reverb depth
mode.
{r; jT. I.j i=i
pJ3
p'j
(-[
rj £a
'The reverb -mode will not
effect any part which the
Reverb
has
been disabled by
software.
More functions
are available to the user, but
they
may not
pro-
vide noticeable effects if the MT-32
is controlled by software.
The
software
overrides user-defined settings when there is a
parameter conflict.