7
Preparations and concepts
«
Preparations and concepts
Turning off the power
You must perform the Shutdown operation before turning the power off. The
Shutdown operation saves the stored parameters before powering-off, and
safely stops the hard disk.
1
Press .
A message of “SHUTDOWN Are you sure?” will appear.
2
Press (Yes).
A message of “Save Current Project before SHUTDOWN?” will appear.
3
Press (Yes).
The current project will save. When save process is completed, the
“SHUTDOWN Completed. You May Turn Off.” message will appear.
4
Turn down the volume of all connected equipment
5
Turn off the rear panel POWER switch.
Make sure that the “You May Turn Off.” message is displayed before you turn
off the power.
• When you turn off the power, you may hear a sound even though the MASTER
knob is turned down; this is not a malfunction.
• While the Shutdown process is occurring, system parameters and project/song
data is being saved. This will require a certain amount of time before the MV-8000
is ready for you to turn off the power.
If you press [EXIT] in step 3,
shutdown will be cancelled. If
you want to shutdown without
saving the current project,
press [F1 (No)].
If you turn off the power without performing Shutdown, or if you turn
off the power before “You May Turn Off.” is displayed, the data and
the MV-8000 itself will be damaged. Roland will accept no
responsibility for any damage that results from your failure to
perform the Shutdown operation.
QuickStart_e.book 7 ページ ２００５年４月２８日 木曜日 午後９時３５分
To Next Page
Loading...
