9
Preparations and concepts
«
Preparations and concepts
Using the SHIFT button
Some buttons have more than one function assigned to them; use [SHIFT] to
access these additional functions.
Hold down and press the desired button.
In this manual, operations accessed using the are indicated as [SHIFT] +
[(button name)]. Use [SHIFT] to access the functions whose names are printed
inside a white frame on the panel of the MV-8000.
Inputting text
Here's how to input alphanumeric characters, such as when specifying a file
name.
1
Move the cursor to the desired location.
The cursor is the highlighted character, as shown
below.
2
Turn the VALUE dial.
Input the desired character. To move to the next place (toward the right) the
right cursor button.
●
Using the numeric keys to input characters
You can use the numeric keys to input alphanumeric characters. Let's try
inputting “Hello!”
1
Press three times.
“H” will be input at the cursor location.
2
Press .
The cursor will move to the right.
3
Press three times.
“E” will be input.
4
Press (A
➜
a/a
➜
A) to switch to lowercase input.
This will switch the type of character that is input. Press [F4 (A
➜
a/a
➜
A)] so
that lowercase character is changed.
5
Press .
The cursor will move to the right.
6
Press four times and press (A
➜
a/a
➜
A).
You can use the SHIFT LOCK
parameter (p.302) to change
the operation of the SHIFT
utton.
If you use the VALUE dial to
input characters, turning the
dial toward the right will select
characters in the order of “a...z,
A...Z, 0...9,!,#...”
When you are inputting
lowercase characters, you can
temporarily input uppercase
characters by holding down
[SHIFT] as you input.
When you are in uppercase
input mode, repeatedly
pressing [3] will cycle in the
order of 3
→G→H→I→
3→G.
When in lowercase character
input mode, pressing [2]
repeatedly will cycle in the
order of 2→D→E→F→2→D.
QuickStart_e.book 9 ページ ２００５年４月２８日 木曜日 午後９時３５分
To Next Page
Loading...
