Roland MV-8800 - Page 46

Effect Block
A-46
MV-8800 Appendices
Tempo Sync
Value: OFF, , , , , , , , , , , , ,
x1 – x4
Set this when synchronizing the Rate setting to the song
tempo. When not synchronizing, set this “OFF.” When
you select the note, the Rate setting is disabled, and the
Rate is set the note length corresponding to the song
tempo.
• If the length of the note is set longer (or shorter) than that
of the possible range of the Rate settings by the change of
song tempo, the Rate can not correspond to the note
length. If “?” appears before the note symbol you set, it is
because the upper (or lower) limit of the setting range has
been exceeded, and that the synchronization is not correct.
Furthermore, the precision of the Rate setting and song
tempo differ. If left to develop over long periods, the two
may gradually drift apart.
Modulation L-R Phase
Value: NonInv, Inv
This sets the phase when the chorus or flanger sound is
mixed in with the source sound in the left and right
channels. When this is set to NORM, the channels are in
phase; when set to INV (inverted), the phases of left and
right channels are inverted relative to each other.
■ Other effect blocks
• NS (Noise Suppressor) (p. 21)
MV-8800_a_e.book 46 ページ ２００６年１１月１０日 金曜日 午前１０時１９分