Roland MV-8800 - Page 47

Effect Block
A-47
MV-8800 Appendices
About MIDI
Effect Block
SpecificationsMIDI Implementation
LimDes (Limiter/De-esser)
You can use either the Limiter or De-esser functions of this
effect. The limiter is an effect that compresses high-level
signals, thereby preventing distortion. De-esser is an effect
that cuts the sibilance in vocals, giving sounds a softer
quality.
Mode
Value: Limiter, De-esser
This determines whether the Limiter or De-esser function
is used.
Limiter Threshold
Value: -60–0 dB
This adjusts the level of the signal at which the Limiter
begins to function (the threshold level).
Limiter Level
Value: -60–12 dB
This sets the level of the signal passing through the
Limiter.
Limiter Release
Value: 0–100
This adjusts the time for the Limiter to stop functioning
after the signal falls back under the threshold level.
De-esser Sens
Value: 0–100
This adjusts the sensitivity of the de-esser effect based
on the input level.
De-esser Frequency
Value: 1.0–10.0 kHz
This adjusts the frequency to which the De-esser effect
is applied. The effect works best at higher frequencies
than that of the settings.
Pitch (Pitch Shifter)
This effect changes the pitch of the source sound.
Pitch
Value: -12–12
This adjusts the pitch in semitone (half-step) increments.
Fine
Value: -100–100
This finely adjusts the pitch shift.
Effect Level
Value: 0–100
This sets the volume of the pitch-shifted sound.
Direct Level
Value: 0–100
This sets the volume of the direct sound.
21 Vocal Multi
MV-8800_a_e.book 47 ページ ２００６年１１月１０日 金曜日 午前１０時１９分