Troubleshooting
A-5
MV-8800 Appendices
About MIDIShortcut Keys Glossary Effect Block SpecificationsPreset Patches / Algorithm List MIDI ImplementationError Messages
Troubleshooting
■
Problems with the sound (continued)
Problem
Cause
Sound is distorted
●
Could you be using an effect that distorts the sound?
➔
In the EFFECTS screen (Screen Guide; p. 229), check the MFX (multi-effect) settings.
●
Could the volume of a specific part be too high?
➔
In the MIXER (INSTRUMENTS PART) screen (Screen Guide; p. 236), decrease the Level.
●
Could the volume of a specific audio track be too high?
➔
In the MIXER (AUDIO TRACK) screen (Screen Guide; p. 235), decrease the Level.
●
Could the MASTER knob be set to an excessively high volume?
●
Does the sound distort when a large number of notes are played simultaneously?
➔
If the overall volume of the entire sampler is raised, distortion may occur when a large number
of notes are played simultaneously.
In the GLOBAL screen (Screen Guide; p. 173), lower the Sampler Output Gain.
●
Is the sound distorted even if you lower the output level settings in the mixer?
➔
It is possible that the sound was recorded in a distorted condition because the input level was
too high during recording. In this case, you’ll have to re-record the material.
Pitch is wrong
●
Is the overall tuning of the entire MV-8800 incorrect?
➔
In the GLOBAL screen (Screen Guide; p. 173), check the Master Tune.
●
Is the pitch incorrect for just a specific patch?
➔
In the PATCH EDIT screen (Screen Guide; p. 118), check the Coarse and Fine settings.
●
Is the pitch incorrect for just a specific partial?
➔
In the PARTIAL EDIT screen (Screen Guide; p. 125), check the Pitch Coarse and Pitch Fine
settings.
➔
In the PARTIAL EDIT (SMT) screen (Screen Guide; p. 141), check the Pitch KF, Tune Coarse,
and Tune Fine settings.
●
Could you have changed the playback pitch for a specific audio phrase?
➔
In the AUDIO PHRASE EDIT screen (Screen Guide; p. 155), check the Coarse Tune and Fine
Tune settings.
●
Could you have changed the playback pitch for a specific audio event?
➔
In the AUDIO EVENT PARAMETER popup (Screen Guide; p. 28), check the Coarse Tune
and Fine Tune settings.
●
Could the pitch be incorrect because of a pitch bend message received from an external
MIDI device?
When you play legato
from a low range of the
keyboard to a high range,
the pitch does not rise all
the way
●
The sample you’re using for legato performance has exceeded the upper pitch limit at
which it can be played.
➔
In the PATCH EDIT (SOLO/PORTAMENTO) screen (Screen Guide; p. 122), turn the Legato
Retrigger setting On.
A partial consisting of
two or more samples
doesn’t sound like a
single note when you
play legato from a low
range of the keyboard to
a high range
●
The respective sample has exceeded the upper pitch limit at which it can be played.
➔
In the PATCH EDIT (SOLO/PORTAMENTO) screen (Screen Guide; p. 122), turn the Legato
Retrigger setting On.
When you play in a high
range of the keyboard,
the playback pitch is
incorrect, or noise is
heard
●
The sample has exceeded the upper pitch limit at which it can be played.
➔
This problem occurs in pitch ranges that would not normally be used. This is not a
malfunction.
MV-8800_a_e.book 5 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
