Troubleshooting
A-6
MV-8800 Appendices
■
Problems with effects
■
Problems with sampling
Problem
Cause
An effect is not applied
●
Could the effect be turned off (disabled)?
➔
In the EFFECTS screen (Screen Guide; p. 229), turn on (enable) the effect that you want to
use.
●
Are the various settings of the effect appropriate?
➔
Check the settings in the EFFECTS EDIT screen (Screen Guide; p. 231).
●
Could the send level of the signal from each part or audio track be turned down?
➔
In each MIXER screen, check the DlyCho Send or Reverb Send settings.
☞
MIXER (AUDIO TRACK) screen (Screen Guide; p. 235)
MIXER (INSTRUMENTS PART) screen (Screen Guide; p. 236)
MIXER (AUX/FX/AUDIO PHRASES/INPUT) screen (Screen Guide; p. 237)
●
Is the MFX (multi-effect) routing appropriate?
➔
In the EFFECTS screen (Screen Guide; p. 229), check the Routing setting.
Problem
Cause
Can’t sample
●
Is there free space in wave memory?
➔
Check the Wave Memory status.
☞
SAMPLING screen (Screen Guide; p. 209), RESAMPLING screen (Screen Guide; p. 209)
➔
If there are unused samples, delete them.
☞
SAMPLE MANAGER screen (Screen Guide; p. 169)
●
Have you made the appropriate settings to initiate sampling?
➔
In the SAMPLING screen (Screen Guide; p. 209), check the Start Trigger setting.
Sampling ends
prematurely
●
Could you be running out of wave memory?
➔
Check the Wave Memory status.
☞
SAMPLING screen (Screen Guide; p. 209), RESAMPLING screen (Screen Guide; p. 209)
➔
If there are unused samples, delete them.
☞
SAMPLE MANAGER screen (Screen Guide; p. 169)
●
Could you have made settings to stop sampling?
➔
In the SAMPLING screen (Screen Guide; p. 209), check the Stop Trigger setting.
When a sample is
assigned to a partial or
audio phrase and played,
it is lower in volume than
when it was originally
sampled
●
The overall volume of the sampler is lowered to prevent distortion from occurring in the out-
put due to filter settings (or other causes) when large numbers of notes are played simul-
taneously.
➔
As appropriate for the sound you’re using or the number of simultaneously played notes, you
can adjust the GLOBAL screen (Screen Guide; p. 173) Sampler Output Gain setting to a
suitable value.
Noise or distortion is
heard in the sampled
sound
●
Is the input sensitivity set appropriately?
➔
Use the SENS knob to adjust the input sensitivity so that the level meter moves within a range
of -12–0 dB.
MV-8800_a_e.book 6 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
