Roland MV-8800 - Page 54

Effect Block
A-54
MV-8800 Appendices
Common (Synth Common)
These are parameters related to overall control of the
synthesizer.
Trigger In
Value: Off, On
This turns the synthesizer sound on and Off. Setting this
from “Off” to “On” corresponds to pressing a key on the
keyboard.
Note Number
Value: 0 (C-1)–127 (G 9)
Sets which key is pressed (note number) and the
strength or force at pressing key (velocity).
• Near the upper and lower note number limits, pitches
may not change, or the changes may be unstable (this
changes with the conditions in each of the parameter
settings).
Velocity
Value: 0–127
This sets the emphasis applied to sounds that are played
in response to the force used in playing the keys (the
velocity).
Portamento
• Sw (Switch)
Value: Off, On
This turns on and Off the portamento effect (the
smooth gliding of the synthesizer sound from one
pitch to another).
• Time (Portamento Time)
Value: 0–100
Sets the transition time for the portamento effect to
change pitches. The elapsed time increases as the
value is increased.
Bend Range
Value: 0–12
This specifies the range within which the pitch is
changed when MIDI Pitch Bend Change messages are
received. You can set this in semitone units, up to a
maximum of one octave.
Modulation Control
Value: -100–100
You can add or subtract an Offset of up to 100 to or from
the parameter values that have already been set when a
MIDI Control Change message (modulation) is received.
OSC1: OSC1 (Vibrato)
OSC2: OSC2 (Vibrato)
VCF: VCF (Wah, Growl)
VCA: VCA (Tremolo)
25 Analog Modeling Bass
MV-8800_a_e.book 54 ページ ２００６年１１月１０日 金曜日 午前１０時１９分