Effect Block
A-53
MV-8800 Appendices
About MIDI
Effect Block
SpecificationsMIDI Implementation
Delay
Delay Time
Value: 1–1200 msec
Sets the delay time, that is, the elapsed time between
the source sound and the delay sound.
When Tempo Sync (explained below) is active, this
setting is not effective, and you cannot make this setting.
L-R Shift
Value: L700–R700 ms
Of the delayed sounds on the left and right, the delay
time is increased on only one side, shifting expression of
the sound. Depending on the time setting, settings
values may be limited. This is disabled in alternate
mode, and you cannot make its setting.
•
The total time you can specify for Delay Time and L-R Shift
is limited to a maximum of 1200 milli- seconds.
Tempo Sync
Value: OFF, , , , , , , , , , , , ,
,
Set this when synchronizing the delay time to the song
tempo. When you select the note, the delay time is set to
match the length of the note. When not synchronizing,
turn this off.
•
If the set note length is longer (or shorter) than the possible
range of delay time settings, the delay time can not
correspond to the note length. If “?” appears before the
note symbol you set, it is because the upper (or lower) limit
of the setting range has been exceeded, and that the
synchronization is not correct. Furthermore, the precision
of the delay time and song tempo differ. If left to develop
over long periods, the two may drift apart.
Feedback Level
Value:0–100
Sets the repeat times for the delay sound. When set to 0,
each delayed sound is played only once.
•
Increasing the value too highly may cause oscillation
in the sound.
Effect Level
Value: 0–100
This sets the volume of the delay sound. Adjust the
setting to achieve a balance relative to the direct sound.
Direct Level
Value: 0–100
This sets the volume of the original source sound.
Ordinarily, this is set to 100.
■
Other effect blocks
•
Chorus (Digital Chorus) (p. 31)
MV-8800_a_e.book 53 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
