Effect Block
A-59
MV-8800 Appendices
About MIDI
Effect Block
SpecificationsMIDI Implementation
Velo Sens (Velocity Sens)
Value: 0–100
This sets the degree to which the volume corresponds to
the value of the Velocity in Common. As the value is
increased, the volume level which follows the Velocity
(the strength or force at pressing key) is increased.
Ext Lev Follow (External Level Follow)
Value: 0–100
Sets the degree to which changes in the tremolo effect
are linked to and controlled by the external input volume
level. As the value is increased, you get an effect in
which the synthesizer sound is played intermittently
according to the rhythm of the external input (such as
drum phrases).
Delay
This digital delay can be switched between monaural and
alternate modes (left and right channels mutually). The
maximum delay of 2400 msec (2.4 seconds) provides long
echoes, fat, or thick sounds.
•
You can also use this simply and effectively as a long delay
machine by setting the VCF input to “ExtIn” (external input)
and then raising only that.
Mode
This switches the mode of the delay.
Delay Time
Sets the delay time, that is, the elapsed time between
the source sound and the delay sound.
Tempo Sync
Value: Off, -
Set this when synchronizing the Delay Time to the song
tempo. When not synchronizing, set this “Off.” When you
select the note, the Delay Time is set to match the length
of the note.
•
If “?” appears before the note symbol you set, it is because
the upper (or lower) limit of the setting range has been
exceeded, and that the synchronization is not correct.
Furthermore, the precision of the Rate setting and song
tempo differ. If left to develop over long periods, the two
may gradually drift apart.
Feedback Level
Value: 0–100
Sets the repeat times for the delay sound. When set to 0,
each delayed sound is played only once. (if the Mode is
“Alt,” delayed sound in each channel are played only
once.)
Value
Explanation
Mono
(Monaural)
A single-input, single-output delay
ALT
(Alternate)
A single-in, dual-out stereo delay in which the
left and right outputs are alternated
(alternated delay).
Mode
Value
Mono
1–2400 msec
Alt 1–1200 msec
If Tempo sync parameter is not off. N/A
MV-8800_a_e.book 59 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
