Effect Block
A-60
MV-8800 Appendices
Effect Level
Value: 0–100
Sets the volume of the delay sound. Adjust this after
getting a balance with the direct level.
Direct Level
Value: 0–100
Sets the volume of the source sound. It is ordinarily set
to 100.
ChoFln (Chorus/Flanger)
This effect can select either a chorus effect, which adds
spaciousness and a wavering effect to the sound, or a
flanger effect, which adds a metallic undulation (rising and
falling sound).
Mode
Value: Chorus, Flanger
This is used to select either the chorus or flanger. Setting
this to “Chorus” adds an effect of spaciousness and
wavering, and setting it to “Flanger” adds the flanger
effect, a metallic undulation (rising and falling sound).
Rate
Value: 0–100
Sets the rate of the wavering and undulation of the
chorus and flanger sounds. This is disabled in Tempo
Sync, and you cannot make this setting.
Depth
Value: 0–100
Sets the depth of the wavering and undulation of the
chorus and flanger sounds.
Manual
Value: 0–100
When the effect mode is switched to Flanger, this sets
the center frequency for the effect, changing the pitch of
the flanger’s metallic sound. This has no effect in Chorus
mode.
Resonance
Value: 0–100
Sets the intensity of the flanger effect. This has no effect
in Chorus mode.
MV-8800_a_e.book 60 ページ ２００６年１１月１０日 金曜日 午前１０時１９分
To Next Page
Loading...
