Need help?Do you have a question about the Roland SH-1 and is the answer not in the manual?
General| Polyphony | Monophonic |
|---|---|
| Envelope Generator | ADSR |
| MIDI | No |
| Year Released | 1979 |
| Type | Analog |
| Oscillators | 1 |
| Waveforms | Sawtooth, Square, Pulse, Noise |
| LFO | Square |
Description of the Keyboard Control Voltage (KCV) printed circuit board assembly.
Detailed schematic and explanation of the KCV circuit's operation.
Description of the Voltage Controlled Oscillator (VCO) printed circuit board assembly.
Detailed schematic and explanation of the VCO circuit's operation.
Description of the Voltage Controlled Filter/Amplifier (VCF/VCA) printed circuit board assembly.
Detailed schematic and explanation of the VCF/VCA circuit's operation.
Description and schematic of the SH-1's power supply unit.
Procedures for adjusting Bender voltage, KCV calibration, and noise level.
Adjusting VCO pitch, width, and tuning controls for accurate pitch.
Calibrating VCO linearity and setting range controls for pitch accuracy.
Adjusting VCF resonance and cutoff frequency width for desired filter response.
Setting VCF frequency, VCA cutoff, and DC balance for optimal sound output.
Identification of parts located on the exterior of the SH-1 synthesizer.
Identification of internal components, including PCBs, wiring, and connectors.
To Next Page
