3
ECO-SOL MAX 3 Ink Switching Method
Introduction
Overall Flow
Preparation before Operations
STEP 1: Checking the Package Contents (P. 4 )
STEP 2: Checking the Replacement Cartridges (P. 4 )
STEP 3: Checking the Necessary Files (P. 5 )
STEP 4: Writing a Memo with the VersaWorks Settings (P. 5 )
Switching the Ink
STEP 1: Updating the Printer Unit Firmware (P. 6 )
(Required time: Approx. 5 minutes)
STEP 2: Switching the Ink (P. 6 )
(Required time: Approx. 20 to 30 minutes)
STEP 3: Cleaning of the Periphery of the Print Heads (Manual Cleaning; P. 8 )
(Required time: Approx. 10 minutes)
STEP 4: Replacing the Wiper and Felt Wiper (P. 11 )
(Required time: Approx. 10 minutes)
STEP 5: Bidirectional Printing Correction (P. 14 )
(Required time: Approx. 5 minutes)
STEP 6: Correcting Misalignment of the Printing and Cutting Positions (P. 14 )
(Required time: Approx. 10 minutes)
STEP 7: Updating VersaWorks (P. 15 )
(Required time: Approx. 10 minutes)
Changes and Precautions
Important: Changes and Precautions after Switching the Ink (P. 19 )
To Next Page
Loading...
