Roland SP-404MKII - Page 128

Appendix
128
Parameter
Value
Explanation
Direct FX1–
Direct FX5
Filter+Drive, Resonator, Sync Delay, Isolator, DJFX Looper, Scatter, Downer, Ha-
Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo, TimeCtrlDly, Super
Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Reverb,
Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan, Chromatic PS,
Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer, Compressor, SX
Reverb, SX Delay, Cloud Delay, Back Spin
You can assign the
effects you like to the
effect buttons on the
top panel.
For details on the
parameters of each
effect, refer to “MFX
List(P.129)”.
OTHER
Parameter
Value
Explanation
Mute Bus
This individually selects the bus to mute with MUTE BUS.
ALL
Both BUS 1 and BUS 2
are muted.
BUS
Only the bus selected
with the [BUS FX] button
is muted.
Input FX
Bypass, Auto Pitch (*), Vocoder (*), Gt Amp Sim (*), Harmony (*), Chorus, JUNO
Chorus, Reverb, TimeCtrlDly, Chromatic PS, Downer, WrmSaturator, 303 VinylSim,
404 VinylSim, Cassette Sim, Lo-fi, Equalizer, Compressor
Effects marked with an (*) are for INPUT FX only.
You can apply effects to
the audio that’s inputted
to this unit.
For details on the
parameters of each
effect, refer to “MFX
List(P.129)”.
Input Bus
You can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which
effects are used).
DRY
The signal is not sent to
BUS 1, BUS 2 (the BUS 1
and BUS 2 effects are not
used).
BUS1, BUS2
The signal is sent to BUS
1 or BUS 2. The effects
set for BUS 1 and BUS 2
are used.
DRY
Routing
This sets the routing for audio sent to the DRY bus.
DRY
Audio is not sent
through BUS 1–BUS 4
(no effects are applied).
BUS3
Audio is inserted just
before BUS 3. The BUS 3
and BUS 4 effects are
applied.
MFX TOP
Scatter, Downer, Ha-Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo,
TimeCtrlDly, Super Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim,
Lo-fi, Reverb, Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan,
Chromatic PS, Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer,
Compressor, SX Reverb, SX Delay, Cloud Delay, Back Spin
Sets the MFX that’s used
when this unit is turned
on.
For details on the
parameters of each
effect, refer to “MFX
List(P.129)”.