Roland SP-404MKII - Super Filter; Wrmsaturator; 303 Vinylsim

Appendix
133
Parameter
Value
Explanation
SYNC
OFF, ON
When this is ON, the effect sound synchronizes
with the tempo.
Super Filter
This is a filter with an extremely sharp slope (attenuation characteristics). The cutoff frequency can be varied cyclically.
Parameter
Value
Explanation
CUTOFF
0–100
Sets the frequency range in which the filter works (the cutoff frequency). Higher values increase
the frequency range.
RESONANCE
0–100
Adjusts the filter’s resonance level.
The larger the value, the more that the frequency range set in CUTOFF is emphasized.
FLT TYPE
Sets the filter type.
LPF
A low-pass filter. This filter lets frequencies pass through that are higher than the frequency range
set in CUTOFF.
BPF
A band-pass filter. This filter lets frequencies pass through that are near the frequency range set in
CUTOFF.
HPF
A high-pass filter. This filter lets frequencies pass through that are higher than the frequency range
set in CUTOFF.
DEPTH
0–100
Sets the depth of the effect.
RATE
0–100
Sets the cycle (period) of the effect.
SYNC
OFF,
ON
When this is ON, the effect sound synchronizes with the tempo.
WrmSaturator
This is a saturator effect with a characteristic warm sound.
This effect may output a very loud sound, depending on how the parameters are set. Use caution not to raise the values too
much.
Parameter
Value
Explanation
DRIVE
0–48 (dB)
Adjusts the strength of the distortion.
Eq LOW
-24–24 (dB)
Adjusts the amount of boost/cut for the low-frequency range.
Eq HIGH
-24–24 (dB)
Adjusts the amount of boost/cut for the high-frequency range.
LEVEL
0–100
Adjusts the volume of the effect sound.
303 VinylSim
This effect models the Vinyl Sim effect of the SP-303. The effect simulates the sound of an analog record playing.
Parameter
Value
Explanation
COMP
0–100
Sets the compression feel, a unique part of the analog record’s sound.
NOISE
0–100
Adjusts the volume of the noise.
WOW FLUT
0–100
Sets the inconsistencies (wow/flutter) heard when the analog record “rotates”.
LEVEL
0–100
Adjusts the volume of the effect sound.
404 VinylSim
This effect models the Vinyl Sim effect of the SP-404SX. The effect simulates the sound of an analog record playing.
Parameter
Value
Explanation
FREQUENCY
0–100
Sets the frequency characteristics of the playback system.
NOISE
0–100
Adjusts the volume of the noise.
WOW FLUT
0–100
Sets the inconsistencies (wow/flutter) heard when the analog record “rotates”.