Appendix
144
While holding down the
[SHIFT] button
Function Explanation
[REC] button
Switches to pattern recording using TR-REC.
This lets you record a sample onto the pattern that’s playing back.
* Enabled only when playing back a pattern
Adjusts the volume for the specified bank overall.
[REMAIN] button (at least
three seconds)
Use this to disable buttons that are not used when playing live (sampling and
edit-related buttons).
[COPY] button
This function prevents the samples and patterns assigned to a pad from being
copied, overwritten by editing or accidentally deleted.
Stops the playback of all samples.
Shortcuts that use the [REMAIN] button
While holding down the [REMAIN] button
Pads [1]–[16]
Sets which sample playback audio is sent to which bus (meaning which
effects are used) for each sample.
Sets the bus send destination for all samples in a bank.
Makes the effect edit screen keep displaying.
You can swap the effects of BUS 1 and BUS 2.
Edits the following parameters on the
pitch/speed settings screen
● SPEED
● PITCH
● VOLUME
● PAN
● BPM
● BPM SYNC
● GATE
● LOOP
Lets you simultaneously edit the parameters of samples that are registered to
the same bank.
Edits the following parameters on the envelope
settings screen
● ATTACK
● HOLD
● RELEASE
● BPM SYNC
● GATE
● LOOP
Lets you simultaneously edit the parameters of samples that are registered to
the same bank.
Shortcuts that use the [VALUE] button
While holding down the [VALUE] knob
Pads [1]–[16]
Selects a sample (no sound is produced).
Also, selects a pattern when [PATTERN SELECT] is lit (the pattern does not play back).
Temporarily bypasses BUS 3 and BUS 4.
[SUB PAD] button
This minimizes the slight differences in timing when you play multiple samples at the
same time.
Effect buttons ([FILTER+DRIVE]–[MFX]
button)
Applies effects only while you hold down the effect buttons (EFFECT GRAB).
Switches the “one-shot playback” sample playback mode on/off.
To Next Page
Loading...
