Appendix
130
DJFX Looper
This effect loops the sound in short cycles.
You can vary the playback direction and playback speed of the input sound to get a turntable-type effect.
LENGTH
Sets the length of the loop.
SPEED
Sets the playback direction and playback speed.
The loop plays backward when this is set to a negative value, stops when this is set to zero,
and plays forward when this is set to a positive value.
LOOP SW
Turn this ON while a sound is playing to make the sound play back in a loop, at a length
specified by the LENGTH parameter.
Turn this OFF to disable the loop.
Scatter
This effect swaps the sound played back by a loop in steps, altering its playback direction and gate length. This gives you the loop
playback a digital groove feeling.
10, 20, 30, 40, 50, 60, 70, 80, 90, 100
Adjusts the scatter depth.
Switches the scatter effect on/off.
Downer
Cyclically slows down the audio playback speed.
Sets how much the playback speed should be slowed down.
RATE
1/32, 1/16, 1/8, 1/4,
1/2, 1, 2
Sets the period at which the playback speed is changed.
Attenuates the high-frequency range.
PITCH
When this is turned ON, pitches that were lowered due to the change in speed are
converted to their original pitch.
RESONANCE
Adjusts the filter’s resonance level.
Increasing the value further emphasizes the effect, for a more unusual sound.
Ha-Dou
This effect generates a wave-like sound based on the input audio.
Adjusts the depth of the effect sound.
Sets the length of the effect sound.
Adjusts the volume of the effect sound.
LOW CUT
FLAT, 20, 25, 31, 40, 50, 63, 80, 100, 125, 160, 200, 250, 315,
400, 500, 630, 800 (Hz)
Sets the frequency range at which the effect
sound is attenuated.
HIGH CUT
630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000,
6300, 8000, 10000, 12500, FLAT (Hz)
Sets the time it takes for the effect to sound.
To Next Page
Loading...
