PROCEDURE
®
Push the PATCH
of
the Edit
Buttons.
The indicator of the PATCH button lights up
show-
ing that it is
now in the
Editing mode.
The Display
changes to as shown below.
T
I
n A
I f r
^^
®:
Factor Number and Factor Name
are displayed.
d);
The value of
each Factor is
displayed.
©
Using the Ten
Keys, assign the number of the
Factor whose
value is to be changed.
As shown
right, push the key in a correct order,
then hit the
Enter Key.
CD
Using the a Diat, change the value as you like.
It may
be necessary to actually listen to the
sound while changing
the
value.
(4)
To
continue
to edit other
Factor, repeat the
step
@
and
®.
It is also
possible to use the a Dial for calling a Factor.
After pushing the
PARAM button, rotate the a
Dial,
and the Factor
shown in the Display will change in
sequence. When
the Factor you wish to
edit
appears
in the Display,
push the
VALUE of the
Edit Buttons,
then change the value with the a
Dial.
This
method is useful for
when you
are editing the
Factor of close
number.
However,
to continue
to
edit other Factor, be sure
to
push the PATCH
then the PARAM buttons,
then
call the Factor
you want
by using
the a Dial.
^
<>
Set the
left number
Set the
right number
Push the
Enter Key
When you have completed editing the Patch
Memory, push the
PATCH
button. The
indicator of
the
PATCH
goes out
and the display returns to the
usual indication except that the Bank and the
Number
of
the Patch Memory flash showing that
the Patch Memory is edited but not yet written
into
memory. If you
call other Patch Memory at
this stage, the edited Patch Memory will be erased.
30
To Next Page
Loading...
