ff you wish to write the edited Tone into the sanne
location, in
other words, to
overwrite it, the Tone
number is already shown in
the Display. So, skip
the
next
step
(3)
and
®
then go to the step
d).
If you wish to write the edited Tone into a different
location, take
the step
®,
then go to
®.
Q)
Set
the
Voice
Memory Switch
©
to the approp-
riate position depending on which of the
JX-
10's memory or Cartridge memory to be used
for the new
location, then assign the new loca-
tion (Tone Number)
using
the Ten
Keys.
®
Push
the Enter Key.
(D
Push
the Enter
Key again.
The Display
will respond with as below showing
that the writing
is completed, then return to the
usual
indication.
l/Mt \
J.
I I
L~i
M i
LJI ML.
(6)
Return the Protect
Switch to the ON position.
To cancel the Tone
Writing mode before execut-
ing the writing,
push
the
WRITE button
instead of
the step
©.
The
edited Tone returns without being
written into
memory,
and the Display returns to
the usual indication.
c. Naming
For
naming a Patch
Memory, IS letters are valid,
and for a Tone,
up to 10 letters can be used.
Naming procedures
are exactly the same for a
Patch
Memory and a Tone, except for
the
first few
steps which are for calling the Patch Memory or
the Tone to be named.
43
To Next Page
Loading...
