Roland TD-7 - Page 165

Illlote On
Status Second Thirit
'.~')nIl§ kit]! Wll
n -- MIDI cliimriel :till tiiill €i:h.l r_‘.h.li:i_3
kit Z\<'ut.e number :23li W 5I'}ll (35 H3)
vv ‘t-’elnt:ity : tllil 'Fi"‘i! (E - 127'}
'l‘hc- Tl) T receivt.-s the message nn the clianiiel iii each section.
Siniutls the instrument assiignc-ijl tn the it-cc-i\'i.~tl mite iiuniher of the current ptilcli
nl the instrument. section. Snnncis the instrument assigneit tn the Performance
section in the range ei Xnte nurutier that is frnm the value of "Lew Note"
tn "Iii Nttte“ set on each Perlnrmant‘-e seclinn.
U Polyphonic Key Pressure
'1 ...: 6 .
-- E ‘III 4-1‘
"\
....
Stiiltis Secnnti
Ant! kltll
n — Wit)! channel :tJl-I ~- till {cit.l ~ (:h.t{~‘-l
Hit .\'nle number :2.'ill 5i)lI (35 93}
vv - \-'ulut: ttltlli Ti’?! if.) 12?}
It the ".-\{terti.it|ch" iii the kllhl parameter is set at l'.'i.\'. the 'l'I.‘t-T recngnizes
the messtme nn the cliunnel ul each section.
if the value is greater than or equal In 40!-l {G1-ti. the decay of the instrument
which cnrrespnmts tn the note number is rnatleshnrter. -
This nwssage is net recurtlect in the Phrase Sequencer.
‘Control Change
C) Volume
Status Secrmti Thirtl
lint-I trill evil
n "I\*llI}i channel ztltl lili lch.l — cli.l6)
vv \-"'i.'ilumi.' ztttiil - TFII (fl -- ii-I?)
ll the "\-‘niiime Rx" nl the .\-*lll'.it parameter is set at t'.i.\'. the Tl) T receives
the message en the channel ni each section.
Ci Panpot
Status Second Third
Bnll U.-=\ ti wit
rt .\-ll]?! channel :0]! ~- tllill (_ch.l -- ch.i6)
\-‘V " Pimpnt :t'.1tlll ~ ‘FRI (D I2?)
if tl1e"l‘t"in Rx" el the .\-lli)l parameter is set at (_i.\', the Tl}-T receives the
niessuge rm the channel uf each section.
1'.) Expression
Stet us Second Third
l'-in I I till! I veil
ri .\-tit")! channel :0!-I til"-‘ti (ch.i ch.tt§l
vvtixpressinn :t3t}tl 7!-‘ll (D -- £2?)
If the "Volume Rx" of the Mil")! parameter is set at ().\‘. the Tl)-7 receives
the message en the channel nl each section.
O Modulation Depth
Status Second
[tn I I O l ll
C? Foot Type
Status Second
ilnil (Hi!
Third
vvll
Third
Wll
tfifieneral Purpose ContrelIar~ 1
Status Second Third
iinil 101! wit
ClGanarai Purpose Controller 2
Status Secenrt Third
linll I ill \'\'H
n =- HID] channel :0l-I ~- OT~'l~l (ch.l - ch.i5)
t-\' Purtinieter value :00}! s TFH {O I27)
Only the cnntrotler set en "Ctrl Chg" of MIDT parameter -receives the message
on the channel ei each section ant! is recnrrled in the Phrase Sequencer.
The result ul receiving the messaitte tlepuniis en the palrarneter i1f"Clrl;\lniie"
til each seclinn.
The value is recorded in the Phrase Sequencer as the position tit the l-Ii’ l-tat
Centre! pedal.
C) Heidi
Status Second Third
ltnll 40!-I wt-I
n=» .\1lI)i channel :0!-I - OFI-I (ch.l ~ ch.lE5)
vv=*Parameter value :OOll - 7Fli (0 -~ t2?)
It the "1-mm Rx” of the MID! parameter is set at ON. the TD-7 receives the
niessage en the channel of each section.
it the "Ctrl Chg" of .\llDl parameter is set at HOLD. the result of receiving
the message depends on the parameter of "Ctrtlvtede" of each section.
If the "Ctrl Chg“ oi MIDI parameter pf each section is set at I-101.1“), this message
is recorder! in the Phrase Sequencer as position of the Hi-Hat Control Pedai.
I Pitch Bend Change
--l QT '1 C‘-
Status Second
lintt til-l mmlt
n -"- MIDI channel :0!-l Flt (ch.l -- ch.tB)
mm.|I Pitch bend value :f.l0lt,0t)ll -- 401-i.00l-I TF1-l.7Fi~l
M8192 - O - +8191)
ll the "Pitch Bend" of the Mil)! parameter is set at OFF. the TD-7 does not
receive the message.
This message is net recorded in the Phrase Sequencer.
IChanne| Mode Massage
IReset All Controllers
ifit C vi
'-l 2'. H Second
tint! 79H DUH
MIDI chunnet :()H Fit (ch.l -- ch.l6)
The Ti)-7 receives the message on the channel at each section.
The Tl)-‘F initiaiizes all the crmtreliers upnn receiving this message.
Pitch Bend Change :0 (Center)
Parapet OFF
Vetume 127
Ex press-inn I27
ilnidl 0
The controller set on "Ctrl Chit” 0
This message is not recorded in the Phrase Sequencer.