Memory/Bank
Architechture
Backup/Restore
The TR-08 Rhythm Composer holds
16 banks of 16 patterns.
A pattern can be up to 32 steps long
when using both A and B sections.
While you may have a beat which is
less than 32 steps - Set A between 1
and 16 in length, and then set B to 0 -
You may not use the B section
separately.
To Choose A Bank
Returning to the Factory Settings
(Factory Reset) $
Data Backup/Restore $
Hold the BANK button and press one
of the pattern buttons [1-16] to select
the Bank you want to work in.
The screen will report the selected
bank as B-01, B-02 etc.
1. While holding down the [2] button,
turn on the power. The [TAP] button
blinks.
If you decide to cancel the factory
reset, turn off the power.
2. Press the [TAP] button to execute
the factory reset.
3. When all buttons blink, turn the
TR-08’s power off, then on again. $
Backup
1. Connect your computer to the
TR-08’s USB port via USB cable.
2. While holding down the [START/
STOP] button, turn on the power.$
It takes about one minute to prepare
the drive. The STEP NO [1]–[16]
indicators show the progress.
3. Open the “TR-08” drive on your
computer.$
The backup files are located in the
“BACKUP” folder of the “TR-08” drive.
4. Copy the backup files into your
computer.
5. After copying is completed, eject the
USB drive.
To Next Page
Loading...
